Page 1 | 2  |  3  |  4  |  5

This is the absolute best looking battery cover on the market. It is constructed from 18 ga. steel and then "show quaility " triple chrome plated for a dynamite look. This cover was designed to work in conjunction with our Fuse Box cover, Item # 60103. With both of them installed on your car , it takes your engine bay to the next level. Installation time 15 to 20 minutes. Fits 2005-2012 incl Gran Sport Auto Trans only

If you want a winning show car you have to have these chrome wiper arms and blade assemblies. These are brand new factory original parts that have been "show quality" triple chrome plated for a show winning look. Installation time is about 10-15 minutes. Fits 2005-2012 incl. Z06 & Gran Sport

INSTALLATION INSTRUCTIONS
Before you begin mark the position of your wipers on the windshield by placing a strip of masking tape on the windshield next to the blades. 1. Remove the windshield wiper arm nut cap by lifting up on it with your finger tips.( you may need to use a small flat blade screw driver to gently pry it loose) 2. Remove the nut holding the wiper arm. 3. Lift the wiper arm away from the windshield as far as it will go and while holding it in that position,grasp the bottom of the arm under where it attaches with the nut and forceably pull it up and away from the stud. (make sure you pull it straight up and not put it in a bind by trying to pull it crooked) 4. Replace with the Chrome wiper Arm by simply sliding it over the stud and making sure the blade aligns with the masking tape that you placed on the windshield earlier. When the wiper is positioned properly install the nut and torque to manufacturers specfications. 5. Replace Chrome Nut Cap. 6. Repeat above procedure for second wiper.

?60180  FUEL RAIL COVERS $895.00
Special Order ....

These are the factory original plastic fuel rail covers that came from the factory on your car. Send your covers to us and we will "show quality" triple chrome plate them for you with a quick return. This gives you a look that you won't believe!! Installation time is about 30 minutes. Fits 2005-2012 incl. Z06 & Grand Sport

INSTALLATION INSTRUCTIONS
1. After removing your oil filler cap on the passenger side and the fuel line on the driver side, simply grasp the bottom of each fuel rail cover and with a slight jerk, lift up on the cover, pulling it away from the engine. 2. Once it releases from the studs, easily work it away from the fuel rails and remove. 3. To replace with your Chrome Fuel Rails simply engage the hooks on your fuel rails, lower the Chrome Fuel Rail Covers into position on the studs and press down until they engage the studs. 4. Replace the oil fill cap and the fuel line.

This is a must have addition. This piece along with our chrome Radiator Support, Item # 60134 will make your engine compartment stand tall. Why waste your time and money on an after market Air Duct that doesn't look good and doesn't perform as expected. Ship us your original Air Duct and we will chrome plate it with a quick return. Installation time is about 30 minutes. Fits 2005-2007

INSTALLATION INSTRUCTIONS
1. Simply loosen the three worm clamps. One at the throttle body and two at the air filters.2. Remove both air filters and the air filter housings. 3. Remove the air duct by gently rocking it back and forth and lifting it straight up until the two rubber grommets come off of the studs in the radiator support and the air duct comes loose from the throttle body. 4. To replace with your Chrome Air Duct just reverse above procedures.

We chrome plate your factory original Z06 air duct. If you want to retain the original factory look and design, only with a lot of added bling, just ship us you air duct and we will plate it for you with a quick return. Installation time is about 30 minutes. Fits 2006-2012.

INSTALLATION INSTRUCTIONS
Remove your factory air duct and replace with your same duct after we chrome plate it for you.

This is a brand new factory original tank that has been completely "show quality" triple chrome plated for a knock out look. Installation time is about 30 minutes. Fits 2005-2012 incl. Z06 & Gran Sport

If you would rather have a cover for your tank, then this is for you. This piece is constructed from 16 ga. steel, hand formed and welded. It is then "show quality" triple chrome plated for an award winning look. Don't forget our etched or plain coolant tank chrome fill cap, Item 60153E. Installation time is about 15 minutes. Fits 2005-2012 incl. Z06 & Gran Sport

This piece is constructed from lazer cut 18 ga. stainless steel, machine formed to fit the curvature of the bottom of your front bumper. It is securely held in place with existing factory bolts and 3m tape. This bracket comes complete with a chrome license plate frame, license plate screws and lock nuts plus four chrome caps to cover the license plate screw heads. This bracket does not touch any part of your exposed body and the mounting can hardly be seen. It looks like it should have come with the car from the factory. Installation time is about 15 -20 minutes. Fits 2005-2012.

INSTALLATION INSTRUCTIONS
This

Page? 1? |? 2  |  3  |  4  |  5

DISCLAIMER User accepts any and all liabilities resulting from the use of Creative Engine Covers, Inc. products. Creative Engine Covers, Inc. is not liable for damages to property or injury to persons resulting from the use of our products. The user agrees to these terms by the act of using these products/